Clear, White Spruce (Satin)
3-4 hours
Osmo Flat Brush
Immediately after use, with soap and water
Interior wall and ceiling panelling as well as doors and cabinets of lightly coloured wood species
16m²/L with one coat
One coat, when signs of wear become visible
2 Coats
125ml, 750ml, 2.5L
Osmo Spray Cleaner
Surface Preparation
Wood surface must be clean, dry and frost-free (moisture content max. 18%, coating temperature at least +10°C).
Osmo Uviwax® UV-Protection is ready to use. Do not thin. Stir well before use.
Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works.
Degrease very resinous woods (e.g. Larch) with Osmo Brush Cleaner and Thinner.
Osmo Uviwax® UV-Protection is to be used alone and solely applied to raw wood. If necessary, sand wood again with fine sandpaper.
Wood treated with Osmo Uviwax® UV-Protection generally only need to be cleaned and recoated.
The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.
Method of Application
With Osmo Flat Brush apply thinly, quickly and evenly along the wood grain and spread well, or use a spray coating method.
Allow to dry for approx. 3-4 hours under good ventilation.
If necessary, sand surface with fine sandpaper (grit P360) before applying the second coat.
After drying, apply a second coat also thinly and quickly.
For renovation works, one coat applied to the clean and dry surface is usually sufficient.
Note
Uviwax® UV-Protection is to be used alone. Please do not dilute or mix with other finishes.
If a surface treated with Uviwax® UV-Protection should be recoated in a different colour, we solely recommend using Osmo Interior Wax.
Using general or multi-purpose cleaners will increase the frequency of maintenance and recoating. Allow finish to fully cure before heavy usage.
Care
Regular Cleaning: Dust mopping. Damp mopping using Osmo Spray-Cleaner.
Occasional Maintenance: Intensive cleaning and refreshing using Osmo Liquid Wax Cleaner or Osmo Maintenance Oil.
Recoating: Simply re-apply one coat onto the clean and dry surface when signs of wear become visible.
Top Tips:
Additional Information:
An elegant water-based wood finish for interior use with a unique long-term UV-protection. Quick drying, does not crack, flake, peel or blister. Water repellent and dirt resistant. The natural yellowing of the wood is dramatically reduced, light wood species remain light for longer.
08:30-17:00 | Monday-Thursday
08:30-16:30 | Friday
Unit 8 Block B, Bullford Business Campus, Kilcoole, Co. Wicklow, Ireland.
Join our group of Osmo enthusiasts for advice, inspiration and project troubleshooting.
All Rights Reserved | Osmo Ireland